Attaching Parts, Seals & Gaskets
Attaching Parts
Nuts, bolts, studs, spring & plain washers
- Head stud – short or long 3/8″ BSF qty. 14
- Head nut 3/8″ BSF qty. 14
- Main bearing stud 7/16″ BSF qty. 8
- Main bearing bolt 7/16″ BSF qty. 2
- Main bearing nut 7/16″ BSF qty. 8
- Main bearing twin tab washer
- Main bearing lock-washer, round, original type
- Main bearing nut, self-locking 7/16″ qty. 4
- Oil gallery to mains, twin tab washer qty. 5
- Oil gallery to block, twin tab washer qty 1
- Water pump stud, long, post-war, 5/16″ qty. 2
- Water pump stud, short, post-war, 5/16″ qty. 2
- Distributor housing stud 5/16″ qty. 3
- Timing sprocket support stud 1/4″ Whit. qty. 2
- Fan mounting stud, long 1/4″ Whit. belt driven dynamo qty. 1
- Fan mounting stud, short, 1/4″ Whit:
- – side dynamo qty. 4
- – belt dynamo qty. 3
- Oil pump cover plate stud 5/16″ BSF qty. 2
- Block to sump stud 3/8″ BSF qty. 1
- Sump to block stud 3/8″ BSF qty. 1
- Sump bolts 3/8″ BSF qty. 11 (pre-war less)
- Bell housing bolts & studs, block & sump 5/16″ BSF qty. 10 (pre-war less)
Seals and Gaskets
Seals
- Crank seal pair, rear
- Crank seal, front, pre- and post-war
Gaskets
- Head Gasket, copper/asbestos substitute
- Sump gasket, pair
- Sump plug gasket, UMB
- Fig-of-eight 0.25mm or 0.40mm Klingersil for our long liners
- Fig-of-eight paper/ali/paper sandwich for short liners
- Exhaust gasket pair, Maglam
- Oil pump gasket, inner
- Oil pump cover gasket
- Thermostat to head gasket, pre- or post-war
- Thermostat housing to hose connector gasket, post-war
- Rocker box gasket, Nitrile cork or rigid material
- Rocker box nuts fibre washers
- Water pump gasket, pre- or post-war
- Carburettor gasket set of three
- Oil filter housing gasket ring
- Sump gauze gasket, CL
- Distributor housing gasket
- Rev counter drive gasket
